Notifier Selectable Output Notification Appliances Manuel d'utilisateur télécharger pdf (Page 2)

Page 2 of 4 — DN-7087:C1 • 11/9/11

STROBE

The strobe shall be a System Sensor SpectrAlert Advance

Model _______ listed to UL 1971 and shall be approved for fire

protective service. The strobe shall be wired as a primary-sig-

naling notification appliance and comply with the Americans

with Disabilities Act requirements for visible signaling appli-

ances, flashing at 1 Hz over the strobe’s entire operating volt-

age range. The strobe light shall consist of a xenon flash tube

and associated lens/reflector system.

HORN/STROBE COMBINATION

The horn/strobe shall be a System Sensor SpectrAlert

Advance Model _______ listed to UL 1971 and UL 464 and

shall be approved for fire protective service. The horn/strobe

shall be wired as a primary-signaling notification appliance

and comply with the Americans with Disabilities Act require-

ments for visible signaling appliances, flashing at 1 Hz over the

strobe’s entire operating voltage range. The strobe light shall

consist of a xenon flash tube and associated lens/reflector sys-

tem. The horn shall have three audibility options and an option

to switch between a Temporal 3 pattern and a Non-Temporal

(continuous) pattern. These options are set by a multiple posi-

tion switch. On four-wire products, the strobe shall be powered

independently of the sounder. The horn on horn/strobe models

shall operate on a coded or non-coded power supply.

OUTDOOR PRODUCTS

SpectrAlert Advance outdoor horns, strobes and horn/strobes

shall be listed for outdoor use by UL and shall operate

between –40°F and 151°F (–40°C and 66°C). The products

shall be listed for use with a System Sensor outdoor/weather-

proof backbox with half-inch and three-fourths-inch conduit

entries.

SYNCHRONIZATION MODULE

The module shall be a System Sensor Sync•Circuit MDL3R or

MDL3W listed to UL 464 and shall be approved for fire protec-

tive service. The module shall synchronize SpectrAlert strobes

at 1 Hz and horns at Temporal 3. Also, while operating the

strobes, the module shall silence the horns on horn/strobe

models over a single pair of wires. The module shall mount to

a 4.688" x 4.688" x 2.125" (11.906 x 11.906 x 5.398 cm) back-

box. The module shall also control two Style Y (class B) cir-

cuits or one Style Z (Class A) circuit. The module shall

synchronize multiple zones. Daisy-chaining two or more syn-

chronization modules together will synchronize all the zones

they control. The module shall not operate on a coded power

supply.

Operating Specifications

• Standard operating temperature: 32°F to 120°F (0°C to

49°C).

• K Series operating temperature: –40°F to 151°F (–40°C

to 66°C).

• Humidity range: 10% to 93% non-condensing (indoor

products).

• Strobe flash rate: 1 flash per second.

• Nominal voltage: regulated 12 VDC/FWR or regulated 24

VDC/FWR. NOTE: Full Wave Rectified (FWR) voltage is a

non-regulated, time-varying power source that is used on

some power supply and panel outputs.

• Operating voltage range: 8 V to 17.5 V (12 V nominal); or

16 V to 33 V (24 V nominal). NOTE: P, S, PC, and SC prod-

ucts will operate at 12 V nominal only for 15 cd and 15/75

cd.

• Input terminal wire gauge: 12 to 18 AWG (3.31 to 0.821

mm²).

• Ceiling-mount dimensions (including lens): 6.8" diame-

ter x 2.5" deep (17.3 cm diameter x 6.4 cm deep).

• Wall-mount dimensions (including lens): 5.6" H x 4.7" W

x 2.5" D (14.2 cm H x 11.9 cm W x 6.4 cm D).

• Horn dimensions: 5.6" H x 4.7" W x 1.3" D (14.2 cm H x

11.9 cm W x 3.3 cm D).

Agency Listings and Approvals

The listings and approvals below apply to SpectrAlert Advance

Selectable Output Notification Devices. In some cases, certain

modules may not be listed by certain approval agencies, or

listing may be in process. Consult factory for latest listing sta-

tus.

• UL Listed: S4011 (HR__, HW__, P2__, P4__, PC2__,

PC4__ models); S5512 (models SCR, SCRH, SCW,

SCWH, SR, SRH, SW, SWH); S3593 (SCRHK, SCRK,

SRHK, SRK).

• ULC Listed: S4011 (HRA, HRKA); S5512 (typically “A”

models, with exception of outdoor strobes). See Canadian

data sheet for listings and specifications.

• FM approved

• MEA: 452-05-E

• CSFM: 7125-1653:0186 (SCR, SCRH, SCW, SCWH, SR,

SRH, SW, SWH); 7300-1653:0188 (P2_, P4_, PC2_, PC4_

modules); 7135-1653:0189 (HR, HRK, HW); 7300-

1653:0187 (SCRHK, SCRK, SRHK, SRK).

Strobe Current Draw,

UL Maximum (mA RMS)

Candela

8 – 17.5 V 16 – 33 V

DC FWR DC FWR

Standard

Candela

Range

15 123 128 66 71

15/75 142 148 77 81

30 NA N/A 94 96

75 NA NA 158 153

95 NA NA 181 176

110 NA NA 202 195

115 NA NA 210 205

High

Candela

Range

135 NA NA 228 207

150 NA NA 246 220

177 NA NA 281 251

185 NA NA 286 258

Horn Current Draw,

UL Maximum (mA RMS)

Sound

Pattern

8 – 17.5 V 16 – 33 V

DC FWR DC FWR

Temporal High 57 55 69 75

Temporal Medium 44 49 58 69

Temporal Low 38 44 44 48

Non-temporal High 57 56 69 75

Non-temporal Medium 42 50 60 69

Non-temporal Low 41 44 50 50

Coded High 57 55 69 75

Coded Medium 44 51 56 69

Coded Low 40 46 52 50

1 2 3 4

Commentaires sur ces manuels

Pas de commentaire

Notifier Selectable Output Notification Appliances Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Sécurité Notifier Selectable Output Notification Appliances